Minerals (Oct 2022)
Adsorption of Polyethyleneimine on Fine Arsenopyrite and the Effect on Its Xanthate Flotation
Abstract
Effective flotation of fine particles is a problem for mineral processing. In this paper, a flocculant mostly used in heavy metal ion treatment was used in an arsenopyrite flotation system. The adsorption behavior and flotation performance of PEI on the xanthate flotation of arsenopyrite were investigated through zeta potential and adsorbed amount measurements, XPS and size distribution detections, and micro-flotation tests. Zeta potential results showed that the adsorption of 40 mg/L polyethyleneimine (PEI) caused an increase in the zeta potential of arsenopyrite, and had only a slight depression on the further adsorption of SBX, which was further confirmed by the results of the adsorbed amount measurements. However, when the dosage of PEI was 150 mg/L, the adsorption of SBX was strongly depressed. This was because moderate PEI only bridged different arsenopyrite particles, and most of the active sites for the SBX adsorption were still exposed; when PEI was in excess, the mineral particles would be covered so that there were not enough active sites for SBX adsorption. Fe and As on the mineral surface were the adsorption sites for the PEI molecules, which were resolved from the chemical shifts in the As/Fe peaks of the XPS spectra. PEI can increase particle size, and moderate PEI dosage can make the particle size suitable for flotation with SBX where bridging and hydrophobic effects take place. The flotation results showed that −20 μm arsenopyrite particles had poor flotation recovery with the SBX collector alone, but when they were treated with 40 mg/L PEI, the recovery largely increased. PEI can serve as an effective flocculant for the flocculation flotation of fine arsenopyrite. A comparison model, showing the possible interactions among reagents, particles, and bubbles in the pulp with different PEI dosages, is proposed.
Keywords