Karman Vortex Creation Using Cylinder for Flutter Energy Harvester Device

Ahmed B. Atrah; Mohd Syuhaimi Ab-Rahman; Hanim Salleh; Mohd Zaki Nuawi; Mohd Jailani Mohd Nor; Nordin Bin Jamaludin

doi:10.3390/mi8070227

Micromachines (Jul 2017)

Karman Vortex Creation Using Cylinder for Flutter Energy Harvester Device

Ahmed B. Atrah,
Mohd Syuhaimi Ab-Rahman,
Hanim Salleh,
Mohd Zaki Nuawi,
Mohd Jailani Mohd Nor,
Nordin Bin Jamaludin

Affiliations

Ahmed B. Atrah: Department of Mechanical and Materials Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM), 43600 UKM Bangi, Selangor, Malaysia
Mohd Syuhaimi Ab-Rahman: Department of Electrical, Electronic, and Systems Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM), 43600 UKM Bangi, Selangor, Malaysia
Hanim Salleh: Institute of Sustainable Energy, Universiti Tenaga Nasional (UNITEN), Jalan IKRAM-UNITEN, 43000 Kajang, Selangor, Malaysia
Mohd Zaki Nuawi: Department of Mechanical and Materials Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM), 43600 UKM Bangi, Selangor, Malaysia
Mohd Jailani Mohd Nor: Department of Mechanical and Materials Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM), 43600 UKM Bangi, Selangor, Malaysia
Nordin Bin Jamaludin: Department of Mechanical and Materials Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM), 43600 UKM Bangi, Selangor, Malaysia

DOI: https://doi.org/10.3390/mi8070227
Journal volume & issue: Vol. 8, no. 7
p. 227

Abstract

Read online

This study presents the creation of a Karman vortex for a fluttering electromagnetic energy harvester device using a cylinder. The effects of two parameters, which are the diameter and the position of the cylinder, were investigated on the Karman vortex profile and the amplitude of the fluttering belt, respectively. A simulation was conducted to determine the effect of the creation of the Karman vortex, and an experiment was performed to identify influence of the position of the cylinder on the fluttering belt amplitude. The results demonstrated that vortex-induced vibration occurred at the frequency of the first natural mode for the belt at 3 cm and 10 cm for the diameter and position of the cylinder, respectively. Under such configuration, an electromagnetic energy harvester was attached and vibrated via the fluttering belt inside the turbulent boundary layers. This vibration provides a measured output voltage and can be used in wireless sensors.

Published in Micromachines

ISSN: 2072-666X (Online)
Publisher: MDPI AG
Country of publisher: Switzerland
LCC subjects: Technology: Mechanical engineering and machinery
Website: https://www.mdpi.com/journal/micromachines

About the journal

Abstract

Keywords