Microstructure and properties of AlxCoCrFeNi high entropy alloys fabricated by laser additive manufacturing

Abstract

In order to study the effect of Al content on the microstructure properties of FeCoCrNi alloy, AlxCoCrFeNi high-entropy alloy (0≤x≤0.9) was prepared by multi-channel laser cladding. The phase composition, microstructure, chemical composition and hardness of the alloy were test by X-ray diffractometry, metallography microscope, scanning electron microscope, electron probe and microhardness tester. The results show that with the increase of Al content, AlxCoCrFeNi high-entropy alloy changes from single FCC phase (x≤0.35) to FCC+BCC biphase structure (0.35 < x < 0.85), and finally to BCC structure (x≥0.85). The microstructure of the high entropy alloy consists of epitaxial columnar dendrites and uniform equiaxed dendrites. When Al content reaches to x=0.5, characteristic structure of spinodal decomposition with alternating light and dark contrast starts to appear between the dendrites, which consists of disordered phase A2 and ordered phase B2.The microhardness test results show that the microhardness of AlxCoCrFeNi alloys almost increases with the increasing Al content and a total of 146% improvement has been achieved when the Al content increases from x=0 to x=0.9. It should be noted that cracks begin to appear in the alloy when the Al content increases to a certain value (x≥0.6).The size and density of cracks increase with the increase of Al content.There are two main reasons. Firstly, the hot-cracking increases since the solidification range widen and their viscosity values near the solidification temperatures increase with the increasing Al content.Besides, cold cracking also increases as the brittle BCC and σ phases increase with the increasing Al content.

Keywords

• laser cladding
• high entropy alloy
• alxcocrfeni
• phase composition
• microstructure