Effects of solution time and cooling rate on microstructures and mechanical properties of 2219 Al alloy for a larger spun thin-wall ellipsoidal head

Abstract

The effects of solution time and cooling rate on microstructures and mechanical properties of 2219 Al alloy for a larger spun thin-wall ellipsoidal head are investigated. It is found that the Al2Cu phases are greatly affected by the solution time. The content of Al2Cu phases first decreases and then stabilizes with increasing the solution time. Moreover, the effects of solution time on the transformation of precipitates are obvious. As the solution time is increased from 35 min to 60 min, almost all the precipitates transfer from GP zones to θ′′ phases. When the solution time is further increased to 110 min, some θ′ phases appear. Meanwhile, the size of θ′′ phases increases, while the density of θ′′ phases drops. These microstructure changes greatly influence the mechanical properties, i.e., the hardness and tensile strengths first increase and then slightly decrease with the continuous increase of the solution time. In addition, if the cooling rate is decreased, the precipitation of coarse equilibrium θ phases is enhanced, but the precipitation of strengthening phases (θ′′, θ′) is restricted. It significantly deteriorates the mechanical properties. Based on the comprehensive analysis, the suitable solution time and cooling method are about 60 min and water cooling.

Keywords

• Alloy
• Solution time
• Cooling rate
• Microstructures
• Mechanical properties
• Spinning