Adsorption Followed by Plasma Assisted Catalytic Conversion of Toluene into CO₂ on Hopcalite in an Air Stream

Abstract

The abatement of toluene was studied in a sequential adsorption-plasma catalysis (APC) process. Within this process, Hopcalite was used as bifunctional material: as adsorbent (storage stage) and as catalyst via the oxidation of adsorbed toluene (discharge stage). It was observed that the desorption and oxidation activity of the adsorbed toluene was significantly affected the process variables. In addition, the adsorption time influenced the CO2 selectivity and CO2 yield by changing the interaction between the catalyst and the plasma generated species. At least four APC sequences were performed for each examined condition suggesting that Hopcalite is very stable under plasma exposure during all the sequences. Consequently, these results could contribute to advance the plasma–catalyst system with an optimal VOC oxidation efficiency. The catalytic activity, amount of toluene adsorbed, amount of toluene desorbed and product formation have been quantified by FT-IR. Moreover, the catalyst was characterized by XRD, H2-TPR, N2 adsorption–desorption analysis and XPS. Hopcalite shows a good CO2 selectivity and CO2 yield when the APC process is performed with an adsorption time of 20 min and a plasma treatment with a discharge power of 46 W which leads to a low energy cost of 11.6 kWh·m−3 and energy yields of toluene and CO2 of 0.18 (±0.01) g·kWh−1 and 0.48 (±0.06) g·kWh−1 respectively.

Keywords

• adsorption
• adsorption plasma catalysis
• hopcalite
• non-thermal plasma
• toluene removal