Investigating micro drilling with electrical discharge machining on nickel-based superalloy: effects of electrode material and diameter

Abstract

Micro drilling using Electrical Discharge Machining (MD-EDM) has emerged as a prominent technique in precision manufacturing, offering the capability to create small and intricate holes. This study focuses on investigating the influence of input process parameters on nickel-based superalloy (Ni3 (Ti, Al)) material, while the electrode materials studied are copper, aluminum and tungsten, with varying electrode diameters of 0.4 mm, 0.5 mm and 0.6 mm. The research encompasses an L9-orthogonal array (L9-OA) in which the Machining Voltage, Peak Current (IP), Pulse off time (Poff) and Servo Standard Voltage (SVR) are varied. Three levels of Machining Voltage (4 volts, 6 volts and 8 volts) and IP are selected. Moreover, scanning electron microscope (SEM) imaging is employed to observe and analyze the morphological characteristics of the drilled holes. The experimental results reveal that the choice of electrode material and diameter significantly influences the SR of the drilled holes. Copper electrodes demonstrate the lowest SR, followed by tungsten and aluminum electrodes. Smaller electrode diameters result in improved surface finish due to reduced discharge energy concentration. Additionally, increasing the Machining Voltage leads to larger discharge energy and heat, resulting in increased SR. SEM imaging demonstrates distinct differences in hole morphology based on the electrode material and diameter, with copper electrodes producing cleaner and more precise holes with minimal recast layer formation compared to aluminum and tungsten electrodes. The influence of Machining Voltage is observed through the presence of craters and debris in higher voltage conditions.

Keywords

• Micro drilling
• electrical discharge machining
• precision manufacturing
• nickel-based superalloy
• surface roughness
• scanning electron microscope