Development of Bisphenol-A-Glycidyl-Methacrylate- and Trimethylolpropane-Triacrylate-Based Stereolithography 3D Printing Materials

Abstract

The main advantages of the three-dimensional (3D) printing process are flexible design, rapid prototyping, multi-component structures, and minimal waste. For stereolithography (SLA) 3D printing, common photocurable polymers, such as bisphenol-A glycidyl methacrylate (Bis-EMA), trimethylolpropane triacrylate (TMPTMA), as well as urethane oligomers, have been widely used. For a successful 3D printing process, these photocurable polymers must satisfy several requirements, including transparency, a low viscosity, good mechanical strength, and low shrinkage post-ultraviolet curing process. Herein, we investigated SLA-type photocurable resins prepared using Bis-EMA, TMPTMA, and urethane oligomers. The flexural strength, hardness, conversion rate, output resolution, water absorption, and solubility of the printed materials were investigated. The degree of conversion of the printed specimens measured by infrared spectroscopy ranged from 30 to 60%. We also observed that 64–80 MPa of the flexural strength, 40–60 HV of the surface hardness, 15.6–29.1 MPa of the compression strength, and 3.3–14.5 MPa of the tensile strength. The output resolution was tested using three different structures comprising a series of columns (5–50 mm), circles (0.6–6 mm), and lines (0.2–5 mm). In addition, we used five different pigments to create colored resins and successfully printed complex models of the Eiffel Tower. The research on resins, according to the characteristics of these materials, will help in the design of new materials. These results suggests that acrylate-based resins have the potential for 3D printing.

Keywords

• 3D printing
• photocurable polymer
• acrylate polymer
• mechanical properties
• stereo-lithography