Tailoring microstructure and mechanical properties of U75V steel manufactured by laser direct energy deposition combining cobalt addition with preheating treatment

Abstract

Laser direct energy deposition (LDED) exhibits great potential for application in rail repairing due to its low cost and high process automation. However, the martensite transformation accompanied by rapid solidification leads to the decrease in the mechanical properties and threatens the service safety. In this study, the reinforcement strategy of combining cobalt (Co) addition with preheating treatment was investigated systematically by combining thermodynamic calculations with experimental characterization to optimize the microstructure and mechanical properties of U75V steel by LDED. The results indicate that cobalt addition can promote the pearlite percentage by facilitating the leftward shift of the continuous cooling transformation (CCT) curve, and refining the interlamellar spacing. But the martensite start (Ms) temperature will also increase from 206.4 °C to 324.1 °C after 7 wt% Co addition. 350 °C preheating treatment on the substrate can also promote the pearlite transformation by elevating the valley temperature of thermal cycling over Ms, as well as the subsequent decrease in cooling rate, but it is not sufficient to prevent martensite formation. A synergistic reinforcement strategy of 7 wt% Co addition and 350 °C preheating was established, which can effectively suppress the occurrence of martensite in the bottom area of deposition layers and expand the pearlite range in the top area. The bonding strength between the substrate and deposition layers has been elevated by ∼20%, accompanied by the increase in elongation and wear resistance. A mixed mode of adhesive and abrasive wear has transformed into a mode dominated by adhesive wear after optimization.

Keywords

• Laser direct energy deposition
• Martensite transformation
• Thermodynamic calculation
• Microstructure
• Bonding strength