Stretch-forming characteristics of austenitic material stainless steel 304 at hot working temperatures

Abstract

The need for sheet metal forming using highly resistant materials such as titanium alloys and stainless steel has increased recently. These materials possess elevated mean flow stress values, which make them difficult to draw at room temperature. To achieve a homogeneous distribution of strain in the stretched component, reduce the load required for plastic deformation, and greatly improve material formability, hot forming is helpful. The goal of the current study is to conduct stretch-forming experiments to investigate the forming characteristics of Austenitic material Stainless Steel (ASS) 304 at Hot working temperatures. Stretch forming experiments have been conducted on the Servo electrical sheet press test machine at 650 and 800°C. The formability has been estimated by constructing a Fracture forming diagram (FFLD), limiting the height of the dome (LDH) and the distribution of the strain of stretched cups. It has been discovered that the limit of forming bounds rises with the temperature reaching 800°C, while the DSA effect causes the necking region – the area between the safe and fracture limits ‒ to decrease with additional temperature rise from 800 to 900°C. Within the experimental limitations, it has been considered that the Hot forming of ASS 304 at 650°C gives the highest strain forming limits with a uniform strain distribution in the stretched cups. From the Formability limit diagram, dome height, and strain distribution, it can be observed that ASS 304 has good limiting strain up to 800°C with lower load application.

Keywords

• hot-working
• formability
• strain distribution
• limiting dome height