A Novel DLLME Method Involving a Solidifying Hydrophobic Deep Eutectic Solvent Using Hydrophilic Deep Eutectic Solvent as the Dispersant for the Determination of Polychlorinated Biphenyls in Water Samples

Abstract

This paper presents a novel dispersive liquid–liquid microextraction (DLLME) method that employs solidified hydrophobic deep eutectic solvent (DES) with hydrophilic DES acting as the dispersant. The aim is to enrich polychlorinated biphenyls (PCBs) from water samples for subsequent determination by gas chromatography–mass spectrometry. The effects of both the hydrophobic DES as the extractant and the hydrophilic DES as the dispersant were thoroughly investigated. Optimization of the key factors influencing extraction efficiency was performed, and the method was subsequently validated. Specifically, a hydrophobic DES called DES2, prepared by combining thymol and decanoic acid in a molar ratio of 3:2, was selected as the extraction solvent. Meanwhile, a hydrophilic DES named DES6, prepared from choline chloride and acetic acid in a molar ratio of 1:2, was chosen as a dispersant. Under the optimal extraction conditions, the developed method exhibited excellent linearity over the concentration range of 0.01–5.0 µg/L, low limits of detection ranging from 3.0 to 5.1 ng/L, relative standard deviations less than 4.1%, and enrichment factors between 182 and 204 for PCBs. Finally, the effectiveness of the developed method was successfully demonstrated through residue determination of PCBs in water samples.

Keywords

• DLLME
• hydrophobic deep eutectic solvent
• hydrophilic deep eutectic solvent
• polychlorinated biphenyls
• water samples