3D free thermal bending of BR1500HS high-strength steel tube: Simulation and experimental investigation

Abstract

Ultra-high strength steel (UHSS) pipes find widespread application in the automotive industry. To address the challenges associated with forming complex structural parts from UHSS pipes, the three-dimensional free thermal bending (3D-FTB) technology for UHSS pipes based on a robotic arm and a bending roller mold was firstly developed. A finite element simulation prediction model for accurately describing the forming process is established and discussed. In this paper, the thermal-mechanical coupling model of the material is established by Gleeble thermal tensile test and modified Arrhenius model. The effects of parameters such as current frequency, current density, axial feed rate, and quenching conditions on forming temperature and microstructure transformation are thoroughly investigated via finite element simulation analysis. The mechanical properties and potential defects of the pipe fittings after forming are analyzed and validated experimentally. The results demonstrate that the finite element simulation and analysis method based on the thermal-force coupling model of the BR1500HS UHSS pipe can accurately predict the forming process parameters. The optimal process conditions are identified as follows: current frequency of 55 kHz, current density of 650 A/mm2, and feed rate of 8 mm/s. Under these parameters, the austenite transformation rate of the pipe fittings reaches an impressive 98 % and the maximum tensile strength reaches 1540 MPa. Lastly, the overall wall thickness distortion rate of the formed pipe remains below 0.2 % and the bending rebound angle exhibits an average reduction of over 80 % compared to that under room temperature conditions.

Keywords

• 3D-FTB
• UHSS pipe
• Induction heating
• Numerical simulation
• Constitutive equation