Analysis of Spinel Based Inclusions During the Last Stage of The Steelmaking Process of SAE 52100

Abstract

Abstract Al2O3 (alumina) and MgO·Al2O3 (spinel) inclusions cause valve obstruction (clogging) in continuous casting and can deteriorate the quality of the final product. In this context, industrial heats of the bearing steel SAE 52100 was examined. Samples were collected in the final steps of the steelmaking process, both after vacuum treatment and during continuous casting. A scanning electron microscope (SEM) equipped with a energy-dispersive spectrometer (EDS) and automated particle characterization analysis was used to characterize the inclusions present in the steel samples. Thermodynamic calculations were performed with the commercial software FactSageTM 7.2. Based on thermodynamic predictions, parameters such as solid fraction, liquid fraction, MgO saturation point of the slags, content of dissolved elements in steel (Al, Mg, Ca,...) and the construction of a phase stability diagram were determined. The results in this study showed a tendency for increase in MgO content in the inclusions with the decrease of %FeO and SiO2 contents in the slag, an increase of binary basicity (%CaO/%SiO2). It is verified that the MgO contents in the slag were close to the saturation, increasing the probability for the formation of inclusions rich in MgO and/or spinel. On the other hand, stability diagrams confirm the formation of spinel inclusions for each of the heats analyzed. During the final step of the steelmaking process, there is a tendency for re-oxidation, which is verified by an increase in the density of inclusions (or total oxygen TO values).

Keywords

• steelmaking
• bearing steels
• inclusions
• re-oxidation
• slags