Brake Wear Particle Emissions of a Passenger Car Measured on a Chassis Dynamometer

Abstract

Brake wear emissions with a special focus on particle number (PN) concentrations were investigated during a chassis dynamometer measurement campaign. A recently developed, well-characterized, measurement approach was applied to measure brake particles in a semi-closed vehicle setup. Implementation of multiple particle measurement devices allowed for simultaneous measurement of volatile and solid particles. Estimated PN emission factors for volatile and solid particles differed by up to three orders of magnitude with an estimated average solid particle emission factor of 3∙109 # km−1 brake−1 over a representative on-road brake cycle. Unrealistic high brake temperatures may occur and need to be ruled out by comparison with on-road temperature measurements. PN emissions are strongly temperature dependent and this may lead to its overestimation. A high variability for PN emissions was found when volatile particles were not removed. Volatiles were observed under high temperature conditions only which are not representative of normal driving conditions. The coefficient of variation for PN emissions was 1.3 without catalytic stripper and 0.11 with catalytic stripper. Investigation of non-braking sections confirmed that particles may be generated at the brake even if no brakes are applied. These “off-brake-event” emissions contribute up to about 30% to the total brake PM10 emission.

Keywords

• brake wear
• chassis dynamometer
• PN emission factor
• non-exhaust emission
• volatile particles