Joint Ship Detection Based on Time-Frequency Domain and CFAR Methods with HF Radar

Abstract

Compact high-frequency surface wave radar (HFSWR) plays a critical role in ship surveillance. Due to the wide antenna beam-width and low spatial gain, traditional constant false alarm rate (CFAR) detectors often induce a low detection probability. To solve this problem, a joint detection algorithm based on time-frequency (TF) analysis and the CFAR method is proposed in this paper. After the TF ridge extraction, CFAR detection is performed to test each sample of the ridges, and a binary integration is run to determine whether the entire TF ridge is of a ship. To verify the effectiveness of the proposed algorithm, experimental data collected by the Ocean State Monitoring and Analyzing Radar, type SD (OSMAR-SD) were used, with the ship records from an automatic identification system (AIS) used as ground truth data. The processing results showed that the joint TF-CFAR method outperformed CFAR in detecting non-stationary and weak signals and those within the first-order sea clutters, whereas CFAR outperformed TF-CFAR in identifying multiple signals with similar frequencies. Notably, the intersection of the matched detection sets by TF-CFAR and CFAR alone was not immense, which takes up approximately 68% of the matched number by CFAR and 25% of that by TF-CFAR; however, the number in the union detection sets was much (>30%) greater than the result of either method. Therefore, joint detection with TF-CFAR and CFAR can further increase the detection probability and greatly improve detection performance under complicated situations, such as non-stationarity, low signal-to-noise ratio (SNR), and within the first-order sea clutters.

Keywords

• binary integration
• CFAR
• HFSWR
• time-frequency analysis
• target detection