Management of Biological Invasions (Apr 2013)
Evaluating high pH for control of dreissenid mussels
Abstract
Two field experiments were carried out using a custom built flow-through laboratory to test the effect of elevated pH on dreissenid musselsas a potential control method. Both experiments tested the ability of dreissenid pediveligers to settle under conditions of elevated pH and thelong-term survival of adult dreissenids under the same conditions. The two experimental sites had different water quality and differentspecies of dreissenids present. The settlement of quagga mussel pediveligers at the lower Colorado River was inhibited with increasing pH.At the maximum achieved pH of 9.1, there was approximately 90% reduction compared to the maximum settlement observed in the controls.Since the settlement was almost as low in pH 8.9 as at pH 9.1, the inhibition in settlement may have been due to the presence of a precipitateformed under high pH conditions rather than the increase in background pH. No mortality of quagga mussel adults was observed in theexperimental pH levels at the lower Colorado River. At San Justo Reservoir, zebra mussel settlement decreased with increasing pH. Newsettlement was almost entirely absent at the highest pH tested (pH 9.6). The observed mortality of adult zebra mussels was low, but did tendto increase with increasing pH. We also tested the response of adult zebra mussels to short-term exposure to very high pH levels (i.e. pH 10,11, and 12). Adult mussels in poor physical condition experienced 90% mortality after 12 hours at pH 12. For unstressed adult zebra mussels,90% mortality was reached after 120 hours at pH 12. Significant mortalities were also observed both at pH 10 and pH 11. From this study,we conclude that pH elevation could be used both as a preventative treatment to eliminate settlement by dreissenid mussels and as an end ofseason treatment to eliminate adults. The high pH treatment would have to be tailored to the site water quality to prevent formation ofprecipitate during treatment and to minimize corrosive action on materials of construction.
Keywords