Application of PCA and Classification for Fault Diagnosis of MAB Installed in Petrochemical Plant Process Facilities

Abstract

In large systems, such as power plants or petrochemical plants, various equipment (e.g., compressors, pumps, turbines, etc.) are typically deployed. Each piece of equipment operates under generally harsh operating conditions, depending on its purpose, and operates with a probability of failure. Therefore, several sensors are attached to monitor the status of each piece of equipment to observe its conditions; however, there are many limitations in monitoring equipment using thresholds such as maximum and minimum values of data. Therefore, this study introduces a technology that can diagnose fault conditions by analyzing several sensor data obtained from plant operation information systems. The equipment for the case study was a main air blower (MAB), an important cooling equipment in the plant process. The driving sensor data were analyzed for approximately three years, measured at the plant. The fault history of the actual process was also analyzed. Due to the large number of sensors installed in the MAB system, a dimension reduction method was applied with the principal component analysis (PCA) method when analyzing collected sensor data. For application to PCA, the collected sensor data were analyzed according to the statistical analysis method and data features were extracted. Then, the features were labeled and classified according to normal and fault operating conditions. The analyzed features were converted with a diagnosis model, by dimensional reduction, applying the PCA method and a classification algorithm. Finally, to validate the diagnosis model, the actual failure signal that occurred in the plant was applied to the suggested method. As a result, the results from diagnosing signs of failure were confirmed even before the failure occurred. This paper explains the case study of fault diagnosis for MAB equipment with the suggested method and its results.

Keywords

• principal component analysis
• prognostics and health management
• fault diagnosis
• classification
• main air blower