Effects of processing parameters on microstructure of semi-solid magnesium alloy

Abstract

In this paper, the effects of pouring temperature of magnesium melt, preheating temperature of the barrel of the screw mixer, and shear rate on the solidified microstructures of semi-solid slurry were investigated by a mechanical stirring semi-solid process. The appropriate processing parameters of slurry preparation were obtained, and the mold filling ability of semi-solid slurry for thin-walled casting was examined. Results indicate that the solid volume fraction of non-dendritic mi-crostructure increases with a decrease in pouring temperature of magnesium melt and the barrel preheating temperature of the screw mixer. Also the grain size of primary a-phase is reduced. Furthermore, the solid volume fraction of semi-solid non-dendritic structure decreases with an increase of shear rate. The fine and round granular microstructure with 30一50 Nm insize of semi-solid AZ91D magnesium alloy was presented. Finally, a 1.0 mm thin-walled casting with a clear contour and good soundness was successfully made by semi-solid rheo-diecasting.

Keywords

• semi-solid metal
• magnesium alloy
• rheocasting
• slurry
• microstructure