Relationship between viscosity, foaming, and structure of CaO–SiO2–Al2O3–MgO–FeO slag with the addition of SiO2 and Al2O3

Abstract

Optimizing the foaming characteristics of slag in electric arc furnaces (EAF) presents a challenging task, affecting electrode heating efficiency and increasing smelting cost. This study explores the impact of adding silicon dioxide (15–35 wt%) and a small quantity of alumina (5–10 wt%) on the viscosity and foaming properties of CaO–SiO2–Al2O3–MgO–FeO slag. Raman spectroscopy and X-ray photoelectron spectroscopy (XPS) were employed to investigate structural changes in the slag melt. The findings reveal that higher levels of silica or a slight increase in alumina content enhance slag polymerization and foaming efficiency. Specifically, a 10 wt% alumina content, in contrast to 5 wt%, leads to high silica content, leading to faster polymerization but relatively lower viscosity. Structural analysis confirms that increasing alumina content, particularly when silica content is high, results in a less stable Al–O–Si structure, causing a shift from Q0 and Q1 units to Q2 and Q3 units, which ultimately reduces viscosity. When the alumina content remains at 5 wt% and silica content increases from 15 wt% to 35 wt%, foaming efficiency improves from 13.06 cm min to 94.97 cm min, a remarkable 627% rise. Moreover, when silica content is 30 wt% and alumina is slightly increased by 5 wt%, there is a notable enhancement in foaming efficiency, rising from 47.11 cm min to 89.16 cm min, while the effect on viscosity is not prominent.

Keywords

• Al2O3
• SiO2
• Slag foam
• Viscosity
• Structure
• EAF