Accuracy Verification of Multiple Floating LiDARs at the Mutsu-Ogawara Site

Abstract

Floating LiDAR systems (FLSs) may replace conventional offshore met masts, and they have been developed well in Europe. However, before using them in Japan, we must determine whether they demonstrate the same performance under the unique East-Asian meteorological and oceanographic conditions. Therefore, herein, we investigate the performance of FLSs by focusing on the differences among models. Four independent wind datasets from three FLSs were simultaneously verified against a reference met mast and vertical LiDAR at a Japanese site. The data availability was confirmed to vary from 62.7 to 98.0% over the period at 63 m. This was strongly affected by the system availability of the buoy and LiDAR, suggesting that buoy system robustness is key to better campaigns with higher data availability. The 10 min averaged wind speed and direction largely satisfied the Carbon Trust’s key performance indicators, with a low sensitivity to wave conditions depending on the buoy shape. The standard deviation of the wind speed and turbulence intensity had poorer accuracy than that of the 10 min averaged statistics because of the wave-induced buoy motion, especially for small buoys. In short, this paper provides an overview of a measurement by FLS in Japan. Also, the unique verification with multiple units suggests the need for a low-motion buoy or motion compensation to improve the measurement accuracy of the turbulence component.

Keywords

• offshore measurement
• floating LiDAR system
• turbulence intensity
• sensitivity analysis
• motion compensation