Mechanical Properties, Crystallization Behaviors and Phase Morphologies of PLA/GTR Blends by Reactive Compatibilization

Abstract

Different ratios of Polylactic acid/Ground tire rubber (PLA/GTR) were prepared by melt blending and adding dicumyl peroxide (DCP) as a reactive compatibilizer. The compatibilizer could initiate a reaction between PLA and GTR to increase the compatibility and interfacial adhesion of the two phases, as indicated by Fourier transform infrared (FTIR) spectrometry and scanning electron microscopy (SEM). Adding the compatibilizer significantly improved the impact strength of the PLA/GTR blends without compromising the tensile strength. The elongation at the break and notched Izod impact strength of the blend increased by 61.8% and 150%, respectively, but there was only a 4.1% decline in tensile strength compared with the neat PLA. The plastic deformation on the impact fractured surface showed that the improvement of toughness could be attributed to the compatibilization initiated by DCP. Therefore, the improvement of the interfacial adhesion and compatibility of the two phases induced a brittle–ductile transition that occurred in the failure of blends. Moreover, the crystallinity of blends reached 40.5% without a further annealing treatment, which was nearly 24 times of the neat PLA, and the crystallization rate was enhanced simultaneously. These exciting findings suggest that compatibilization can provide a promising avenue for fabricating GTR-toughened PLA blends with balanced stiffness–toughness.

Keywords

• polylactide
• ground tire rubber
• compatibilization
• crystallization
• balanced stiffness–toughness