Study on the Deformation Behavior of Two Phases during the Low Cycle Fatigue of UNS S32750 Duplex Stainless Steel

Abstract

In this paper, the deformation behavior of UNS S32750 (S32750) duplex stainless steel during low cycle fatigue was studied by controlling the number of cycles. The microstructure of the specimens under different cycles was characterized by optical microscope (OM), scanning electron microscope (SEM), electron backscatter diffraction (EBSD), and transmission electron microscope (TEM). The microhardness of the two phases was measured by a digital microhardness instrument. The results showed that the microhardness of ferrite increases significantly after the first 4000 cycles, while the austenite shows a higher strain hardening rate after fatigue fracture, and the microhardness of ferrite and austenite increases by 23 HV and 87 HV, respectively. The two-phase kernel average misorientation (KAM) diagram showed that the continuous accumulation of plastic deformation easily leads to the initiation of cracks inside the austenite and at the phase boundaries. The evolution of dislocation morphology in the two phases was obviously different. With the increase in cycle number, the dislocation in ferrite gradually transforms from dislocation bundles and a dislocation array to a sub-grain structure, while the dislocation in austenite gradually develops from dipole array to an ordered Taylor lattice network structure.

Keywords

• S32750 duplex stainless steel
• low cycle fatigue
• plastic deformation
• dislocation evolution