Time-Dependent Behavior of Ultra-High Performance Concrete Beams under Long-Term Bending Loads

Abstract

In the past, scholars have studied the creep of UHPC, mainly in compression and tension but not bending creep. In this research, 20 ultra-high performance concrete (UHPC) beams were tested for bending creep under long-term loading, and the changes of beam deflection, temperature, and humidity with time were obtained for 445 days of continuous loading. The deflection patterns of UHPC beams with time were analyzed for different steel fiber content, curing systems, water/binder ratio, sand/binder ratio, and stress levels. The results showed that steel fiber had an obvious inhibition effect on initial deflection, but a dosage of steel fiber too high would offset part of the inhibition effect of steel fiber on creep. The use of heat treatment had a better inhibition of creep in the later stage of UHPC, but heat treatment must be matched with necessary moisture content, and hot water maintenance was the most efficient. Both a high water/binder ratio and high stress level increased the bending creep of the specimen. Bending creep increased with the increase in the sand/binder ratio. Therefore, attention should be paid to the total amount and ratio of cementitious materials and fine aggregates in UHPC.

Keywords

• UHPC
• steel fiber
• bending creep
• heat treatment
• water/binder ratio