Aerodynamics of two parallel bristled wings in low Reynolds number flow

Abstract

Abstract Most of the smallest flying insects use bristled wings. It was observed that during the second half of their upstroke, the left and right wings become parallel and close to each other at the back, and move upward at zero angle of attack. In this period, the wings may produce drag (negative vertical force) and side forces which tend to push two wings apart. Here we study the aerodynamic forces and flows of two simplified bristled wings experiencing such a motion, compared with the case of membrane wings (flat-plate wings), to see if there is any advantage in using the bristled wings. The method of computational fluid dynamics is used in the study. The results are as follows. In the motion of two bristled wings, the drag acting on each wing is 40% smaller than the case of a single bristled wing conducting the same motion, and only a very small side force is produced. But in the case of the flat-plate wings, although there is similar drag reduction, the side force on each wing is larger than that of the bristled wing by an order of magnitude (the underlying physical reason is discussed in the paper). Thus, if the smallest insects use membrane wings, their flight muscles need to overcome large side forces in order to maintain the intended motion for less negative lift, whereas using bristled wings do not have this problem. Therefore, the adoption of bristled wings can be beneficial during upward movement of the wings near the end of the upstroke, which may be one reason why most of the smallest insects adopt them.