A new innovative breakthrough in the production of salt from bittern using a spray dryer

Abstract

Spray dryer had long been used to dry liquid materials and produce dry crystalline products. However, the drying of the bittern to produce quality salt crystals has not been widely published. Therefore, the purpose of this study was to examine the effect of drying conditions of the bittern using a spray dryer to produce salt with a high natrium chloride (NaCl) content. Drying was carried out in the hot air temperature (105–125 °C), drying air flow rate (25–45 ml/min), feed flow rate (20–30 ml/min), and concentration of maltodextrin (10–30%). The parameters were observed water content, NaCl content, yield, and mean particle diameter size (MPDS). The results showed that the inlet air temperature of 125 °C can significantly reduce the water content faster and produce higher NaCl levels than the inlet air temperature of 105 °C. The salt crystals produced at higher maltodextrin concentrations have lower water content and high NaCl content. The best-operating conditions are at a hot air temperature of 125 °C, a drying airflow rate of 45 m/s, and a maltodextrin concentration of 25% because it produces salt crystals with high NaCl content. Overall, these results indicate that the bittern can be dried using a spray dryer with potential NaCl content as a raw material for the pharmaceutical industry.

Keywords

• Bittern
• Drying air flow rate
• Inlet air temperature
• Natrium chloride
• Pharmaceutical industry