Calculation of Dose Perturbation in Radiotherapy of Head and Neck Tumors Due to the Presence of Dental Implants: A Monte Carlo Study

Abstract

Purpose: The presence of a dental implant across the irradiation beam has the potential to perturb the dose distribution. In this study, the effect of different commercial dental implants on dose distribution was investigated in electron beam therapy. Materials and Methods: The Varian 2100 C/D linear accelerator (Linac) head was modeled precisely with proper components for electron mode (6 and 9 MeV) by MCNPX 2.6.1 and was benchmarked according to the International Atomic Energy Agency (IAEA) protocol, TRS -398. Dose distribution was calculated for Six different implant materials, including Titanium, Titanium alloy, Zirconia (Y-TZP), Zirconium oxide, Alumina, and PolyetherEtherKetone (PEEK), and for Four different scenarios. Results: The highest and lowest increasing doses occurred for Y-TZP (114.44% and 108.69% for 6 and 9 MeV, respectively) and PEEK (104.85% and 98.84% for 6 and 9 MeV, respectively) directly in front of the implant, respectively. By removing an implant from the jaw, an increasing dose was not seen, but an increasing dose occurred behind its depths in the bone region (31.81 %). Conclusion: The amount of dose perturbation due to the dental implant's presence depends on the beam energy, mass density, and atomic numbers of implants. Maximum and minimum increased doses were estimated for Y-TZP and PEEK implants, respectively. Considering the correction factors due to the presence of high density and atomic number dental implants are essential to estimate the accurate dose delivery in radiotherapy with electron beams.

Keywords

• Dental Implant
• Dose Distribution
• Electron Therapy
• Monte Carlo Calculation
• Radiotherapy
• Head and Neck Tumors