Energy Reports (Sep 2023)
A virtual synchronous generator control method for remote island power system considering dynamic voltage stability
Abstract
Remote island power systems are difficult to install renewable energy sources (RES) because of the small system capacity and the large impact of intermittency of RES. Virtual synchronous generators (VSG) can equip inverters with the inertia of synchronous generators and can suppress frequency and voltage fluctuations. This paper proposes a VSG control method for dynamic voltage stability in remote island power systems. In conventional VSG control methods, the command of active and reactive power is determined by the Droop characteristics of frequency and transmission line voltage. However, the command are not based on dynamic voltage stability indices. Therefore, the compensation amount of active and reactive power is inappropriate. The proposed method determines the command of active and reactive power based on dynamic voltage stability indices. The dynamic voltage stability index considers the critical boundary index (CBI). The CBI is defined as the distance between the operating point of active and reactive power flowing through a transmission line and the stability limit curve calculated from the power flow between two bus lines. The proposed method improves dynamic voltage stability by determining power command so that the operating points of active and reactive power are closer to the origin direction. Simulation verification is performed for load increase and three-phase ground fault. In the three-phase ground-fault simulation, FRT requirements are considered to verify continued operation and the case of gate blocking. The conventional Droop control and the proposed method are compared for the case of continued operation with FRT requirements during load increase and ground fault. Simulation verification results show that the proposed method improves the dynamic voltage stability compared to the conventional method. Furthermore, it is shown that the proposed method is capable of stable continuous operation of the system even after a transmission line failure considering the FRT requirement.
