Concurrent investigation of antimony chalcogenide (Sb2Se3 and Sb2S3)-based solar cells with a potential WS2 electron transport layer

Abstract

Antimony (Sb) chalcogenides such as antimony selenide (Sb2Se3) and antimony sulfide (Sb2S3) have distinct properties to be used as absorber semiconductors for harnessing solar energy including high absorption coefficient, tunable bandgap, low toxicity, phase stability. The potentiality of Sb2Se3 and Sb2S3 as absorber material in Al/FTO/Sb2Se3(or Sb2S3)/Au heterojunction solar cells (HJSCs) with 2D tungsten disulfide (WS2) electron transport layer (ETL) layer has been investigated numerically using SCAPS-1D solar simulator. A systematic investigation of the impact of physical properties of each active material of Sb2Se3, Sb2S3, and WS2 on photovoltaic parameters including layer thickness, carrier doping concentration, bulk defect density, interface defect density, carrier generation, and recombination. This study emphasizes the exploration of causes of low performance of actual devices and demonstrates the individual variation in the open-circuit voltage (VOC), short-circuit current density (JSC), fill factor (FF), power conversion efficiency (PCE) and quantum efficiency (QE). Thereby, highly potential heterostructures of Al/FTO/WS2/absorber (Sb2Se3 or Sb2S3)/Au proposed, in which, the PCE over 28.20 and 26.60% obtained with VOC of 850 and 1230 mV, Jsc of 38.0 and 24.0 mA/cm2, and FF of 86.0 and 89.0% for Sb2Se3 and Sb2S3 absorber, respectively. These detailed findings revealed that the Sb-chalcogenide heterostructure with potential WS2 ETL can be used to realize the fabrication of feasible thin film solar cells and thus the design of high-efficiency high-current (HEHC) and high-efficiency high-voltage (HEHV) solar panels.

Keywords

• Heterojunction solar cell
• Sb2Se3
• Sb2S3
• WS2 electron transport layer
• SCAPS-1D