Formability of Materials with Small Tools in Incremental Forming

Abstract

Abstract Single point incremental forming (SPIF) is an innovative sheet forming process with a high economic pay-off. The formability in this process can be maximized by executing forming with a tool of specific small radius, regarded as threshold critical radius. Its value has been reported as 2.2 mm for 1 mm thick sheet materials. However, with a change in the forming conditions specifically in the sheet thickness and step size, the critical radius is likely to alter due to a change in the bending condition. The main aim of the present study is to undertake this point into account and develop a relatively generic condition. The study is composed of experimental and numerical investigations. The maximum wall angle (θ max ) without sheet fracturing is regarded as sheet formability. A number of sheet materials are formed to fracture and the trends correlating formability with normalized radius (i.e., R/T o where R is the tool-radius and T o is the sheet thickness) are drawn. These trends confirm that there is a critical tool-radius (R c ) that maximizes the formability in SPIF. Furthermore, it is found that the critical radius is not fixed rather it shows dependence on the sheet thickness such that R c = βT o , where β varies from 2.2 to 3.3 as the thickness increases from 1 mm to 3 mm. The critical radius, however, remains insensitive to variation in step size ranging from 0.3 mm to 0.7 mm. This is also observed that the selection of tool with R < R c narrows down the formability window not only on the higher side but also on the lower side. The higher limit, as revealed by the experimental and FEA results, diminishes due to excessive shearing because of in-plane biaxial compression, and the lower limit reduces due to pillowing in the bottom of part. The new tool-radius condition proposed herein study would be helpful in maximizing the formability of materials in SPIF without performing experimental trials.

Keywords

• Incremental forming
• Critical tool-radius
• Formability curve
• Finite element analysis