Energy Harvesting on AB-Class Power Amplifier Applying Thermoelectric Generators in Push–Pull Mode

Abstract

Amplifiers are among the most commonly used circuits in electronics, performing a variety of functions in a wide range of electronic systems. Depending on the application and design, each amplifier generates waste heat. For power amplifiers that operate at low efficiency and high output power, the amount of wasted energy can be significant. This paper presents an energy harvesting system based on the application of thermoelectric generators on the output transistors of the AB-Class power amplifier. The converted electrical energy can be used in several ways, feeding the energy back into the power supply (increasing the “efficiency”) or powering surrounding sensors and sub-circuits. In this work, a comparative analysis of the successfully converted energy obtained from different generator models in various thermal configurations was carried out. All measurements are performed on an experimentally established setup. Due to the low thermoelectric efficiency of the generators as well as the realized low temperature gradient, only 0.84% of the waste heat can be converted into electrical energy in the best case scenario. Finally, a new thermal push–pull concept was presented, the main purpose of which is to generate additional energy and protect semiconductor components from overheating.

Keywords

• thermoelectric generator
• AB-Class power amplifier
• energy harvesting
• thermal matching