Traditional Artificial Neural Networks Versus Deep Learning in Optimization of Material Aspects of 3D Printing

Abstract

3D printing of assistive devices requires optimization of material selection, raw materials formulas, and complex printing processes that have to balance a high number of variable but highly correlated variables. The performance of patient-specific 3D printed solutions is still limited by both the increasing number of available materials with different properties (including multi-material printing) and the large number of process features that need to be optimized. The main purpose of this study is to compare the optimization of 3D printing properties toward the maximum tensile force of an exoskeleton sample based on two different approaches: traditional artificial neural networks (ANNs) and a deep learning (DL) approach based on convolutional neural networks (CNNs). Compared with the results from the traditional ANN approach, optimization based on DL decreased the speed of the calculations by up to 1.5 times with the same print quality, improved the quality, decreased the MSE, and a set of printing parameters not previously determined by trial and error was also identified. The above-mentioned results show that DL is an effective tool with significant potential for wide application in the planning and optimization of material properties in the 3D printing process. Further research is needed to apply low-cost but more computationally efficient solutions to multi-tasking and multi-material additive manufacturing.

Keywords

• 3D printing
• material
• process optimization
• artificial neural network
• deep learning