Microstructure and properties of metal inert gas welded joints in a novel Al–Mg–Zn–Er–Zr alloy

Abstract

Metal inert gas (MIG) welding of a novel Al-5.82Mg-0.61Zn-0.14Er-0.11Zr alloy was performed using ER5E61 and ER5B71 filler wires. The effect of the two filler wires on microstructures and mechanical properties of MIG welded joints was investigated. The study shows that fully penetrated joints are obtained by MIG welding process filled with ER5E61 and ER5B71 wires. Compared with ER5B71, the weld metal (WM) with ER5E61 exhibits a coarse structure and high solid solution of Mg and Mn elements. After the tensile test, the WM with ER5E61 and ER5B71 wires is composed of elongated coarse grains with a higher proportion of low angle grain boundaries (LAGBs). In addition, the lattice rotation occurring within the grains, indicating that single grain has an unevenly plastic deformation after the tensile test. The average microhardness of the WM is 83.4 HV and 82.9 HV for ER5E61 and ER5B71 wire, which is the lowest microhardness in the MIG welded joint. The average ultimate tensile strength (UTS) and elongation index (EI) of the MIG joints are 327.7 MPa and 8.5% for ER5E61 wire, and 314.3 MPa and 8.2% for ER5B71 wire, suggesting the MIG welded joint with ER5E61 wire achieves a good combination of strength and ductility. Quantitative assessments of the effects of different strengthening mechanisms on the strength reveal that dislocation strengthening and solid solute strengthening are the main factors to obtain a higher strength of welded joints with ER5E61.

Keywords

• Al-Mg-Zn-Er-Zr alloy
• Welding filler wire
• Metal inert gas welding
• Microstructure
• Mechanical properties