Clean Technologies and Recycling (Sep 2023)

Effect of moisture absorption-desorption cycles, UV irradiation and coupling agent on the mechanical performance of pinewood waste/polyethylene composites

  • Javier Guillén-Mallette,
  • Irma Flores-Cerón ,
  • Soledad Cecilia Pech-Cohuo,
  • Edgar José López-Naranjo,
  • Carlos Vidal Cupul-Manzano ,
  • Alex Valadez-González,
  • Ricardo Herbé Cruz-Estrada

DOI
https://doi.org/10.3934/ctr.2023013
Journal volume & issue
Vol. 3, no. 3
pp. 193 – 220

Abstract

Read online

The effects of UV radiation, a maleic anhydride grafted polyethylene (MAPE) coupling agent and moisture cycling exposure on wood plastic composites (WPC) made from pinewood waste (PW) and high-density polyethylene (HDPE) on their tensile and flex properties, were studied. First, the effect of UV radiation and the presence of anhydride grafted polyethylene on the absorption-desorption behavior of the compounds was evaluated and then its effect on the mechanical properties. Scanning electron microscopy (SEM) was used to analyze the surfaces of the samples subjected to these factors and their subsequent damage in fracture zones of the samples. The moisture absorption-desorption process exhibited a two-stage mechanism: the first is significant increases in the absorption values in the first five cycles, and a second stabilization stage that occurs from the sixth cycle onwards. The first stage includes several steps: initial absorption and delamination; capillary action and polymer-wood interaction; and swelling, fiber-matrix interaction and mechanical damage. The second stage involves the balance and stabilization step. Statistically, it was found that the changes in the humidity values in the absorption and desorption cycles show that UV radiation has a significant contribution with the effect of increasing the absorption and desorption values, while the presence of anhydride grafted polyethylene as a lesser effect with an effect of decreasing those values. The tensile and flexural properties of the compounds were significantly affected by UV radiation and moisture cycling. Taking the sample without anhydride grafted polyethylene and without treatments as a reference, only a slight increase of 5–12% in its tensile and flexural properties was observed, while treatments with UV radiation and absorption-desorption cycles reduced them by up to 45%. The SEM analysis confirmed the deterioration of the composites in the form of microcracks, delamination, interfacial voids and mechanical failures in both the wood filler and the polyethylene matrix, especially in the samples exposed to ultraviolet radiation, where this deterioration was lower in the samples containing anhydride grafted polyethylene.

Keywords