Optimization design of support structure based on 3D printing technology

Abstract

Abstract Parts are often warped and deformed when they are molded using selective laser melting (SLM) technology. Thus, it is necessary to study the addition support modes of parts molded using SLM. Consequently, we designed dendritic, E-stage and conical supports, having different structural parameters and different partitions using Magics, and then, we analyzed their performances using the finite element software Abaqus. The structural parameters of the supports were optimized and finally tested using SLM molding technology. The maximum stress concentration was found for dendritic supports, followed by E-stage supports, and then conical supports. The stress concentration and deformation level of Scheme 2 were less than those of Scheme 1. The stress intensity and deformation levels for two partitions were less than those for three partitions. For parts molded by SLM, the deformation was maximum for conical supports, followed by dendritic supports, and then E-stage supports. When gradient supports of similar volumes were added, additional partitions did not effectively improve the molding quality. When supports of similar volumes were added, adding gradient supports did not effectively improve the molding quality. The results provide a basis for the application of SLM in molding high-precision parts.

Keywords

• Selective laser melting
• 316L alloy
• Supporting structure
• Warping deformation
• Optimal design