One approach to determining the optimal coefficient of slenderness scraping and tool materials when processing on a lathe for known machine

Abstract

Starting from the expression for the thrust in the field of full utilization cross section scrapings and tool life, an expression is derived for the maximum required thrust of universal machine. Then, using a working diagram the analysis of the main features of the simultaneous utilization of machines was performed and determined the optimal area of its utilization for given optimal diameter of treatment. Based on this, the well-known machine using its structural details and the corresponding function workability, derived relations to determine the optimal coefficient slenderness of scrapings suitable for practical use. In this case we think that is known critical material for work piece. Considering the critical and authoritative material of the work piece, based on the expression for the cutting speed was determined by the characteristic constant workability as the basis for establishing optimum tool material which is adequate for optimum regime. Both obtained relation can be considered as general model that can be applied directly to solving setting problems. Also, given the possibilities of practical application of the presented relations, especially in the case of other typical kinds of treatment. Finally, the model is verified on a one calculation example from practice for a Specific machine tool, where certain important characteristics of the optimal treatment are defined.

Keywords

• rough lathe processing
• optimal coefficient of slenderness of scrapings
• the optimal tool material
• the main characteristics of machine tools
• machine tool working field
• maximum force
• optimum speed
• the optimum diameter of treatment