Enhanced Injection Molding Simulation of Advanced Injection Molds

Béla Zink; Ferenc Szabó; István Hatos; András Suplicz; Norbert Krisztián Kovács; Hajnalka Hargitai; Tamás Tábi; József Gábor Kovács

doi:10.3390/polym9020077

Polymers (Feb 2017)

Enhanced Injection Molding Simulation of Advanced Injection Molds

Béla Zink,
Ferenc Szabó,
István Hatos,
András Suplicz,
Norbert Krisztián Kovács,
Hajnalka Hargitai,
Tamás Tábi,
József Gábor Kovács

Affiliations

Béla Zink: Department of Polymer Engineering, Faculty of Mechanical Engineering, Budapest University of Technology and Economics, Műegyetem rkp. 3., H-1111 Budapest, Hungary
Ferenc Szabó: Department of Polymer Engineering, Faculty of Mechanical Engineering, Budapest University of Technology and Economics, Műegyetem rkp. 3., H-1111 Budapest, Hungary
István Hatos: Department of Materials Science and Technology, Széchenyi István University, Egyetem tér 1, H-9026 Győr, Hungary
András Suplicz: Department of Polymer Engineering, Faculty of Mechanical Engineering, Budapest University of Technology and Economics, Műegyetem rkp. 3., H-1111 Budapest, Hungary
Norbert Krisztián Kovács: Department of Polymer Engineering, Faculty of Mechanical Engineering, Budapest University of Technology and Economics, Műegyetem rkp. 3., H-1111 Budapest, Hungary
Hajnalka Hargitai: Department of Materials Science and Technology, Széchenyi István University, Egyetem tér 1, H-9026 Győr, Hungary
Tamás Tábi: Department of Polymer Engineering, Faculty of Mechanical Engineering, Budapest University of Technology and Economics, Műegyetem rkp. 3., H-1111 Budapest, Hungary
József Gábor Kovács: Department of Polymer Engineering, Faculty of Mechanical Engineering, Budapest University of Technology and Economics, Műegyetem rkp. 3., H-1111 Budapest, Hungary

DOI: https://doi.org/10.3390/polym9020077
Journal volume & issue: Vol. 9, no. 2
p. 77

Abstract

Read online

The most time-consuming phase of the injection molding cycle is cooling. Cooling efficiency can be enhanced with the application of conformal cooling systems or high thermal conductivity copper molds. The conformal cooling channels are placed along the geometry of the injection-molded product, and thus they can extract more heat and heat removal is more uniform than in the case of conventional cooling systems. In the case of copper mold inserts, cooling channels are made by drilling and heat removal is facilitated by the high thermal conductivity coefficient of copper, which is several times that of steel. Designing optimal cooling systems is a complex process; a proper design requires injection molding simulations, but the accuracy of calculations depends on how precise the input parameters and boundary conditions are. In this study, three cooling circuit designs and three mold materials (Ampcoloy 940, 1.2311 (P20) steel, and MS1 steel) were used and compared using numerical methods. The effect of different mold designs and materials on cooling efficiency were examined using calculated and measured results. The simulation model was adjusted to the measurement results by considering the joint gap between the mold inserts.

Published in Polymers

ISSN: 2073-4360 (Online)
Publisher: MDPI AG
Country of publisher: Switzerland
LCC subjects: Science: Chemistry: Organic chemistry
Website: http://www.mdpi.com/journal/polymers/

About the journal

Abstract

Keywords