Applied Sciences (May 2022)

A Modified Compact Flexible Vivaldi Antenna Array Design for Microwave Breast Cancer Detection

  • Ayman M. Qashlan,
  • Rabah W. Aldhaheri,
  • Khalid H. Alharbi

DOI
https://doi.org/10.3390/app12104908
Journal volume & issue
Vol. 12, no. 10
p. 4908

Abstract

Read online

In this paper, a compact, flexible Vivaldi antenna is designed, and an array of nine identical antennas of this type is used as a microwave breast imaging model to detect cancerous tumors in the multilayers phantom model presented in this paper. The nine-antenna array is used to measure the backscattering signal of the breast phantom, where one antenna acts as a transmitter and the other eight antennas act as receivers of the scattered signals. Then, the second antenna is used as a transmitter and the other antennas as receivers, and so on till we have gone through all the antennas. These collected backscattered signals are used to reconstruct the image of the breast phantom using software called “Microwave Radar-based Imaging Toolbox (MERIT)”. From the reconstructed image, the tumor inside the breast model can be identified and located. Different tumor sizes in different locations are tested, and it is found that the locations can be determined irrespective of the tumor size. The proposed modified Vivaldi antenna has a very compact size of 25 × 20 × 0.1 mm3 and has a different geometry compared with conventional Vivaldi antennas. The first version of the antenna has two resonant frequencies at 4 and 9.4 GHz, and because we are interested more in the first band, where it gives us sufficient resolution, we have notched the second frequency by etching two slots in the ground plane of the antenna and adding two rectangular parasitic elements on the radiating side of the antenna. This technique is utilized to block the second frequency at 9.4 GHz, and, as a result, the bandwidth of the first resonant frequency is enhanced by 20% compared with the first design bandwidth. The modified antenna is fabricated on Polyimide flexible material 0.1 mm thick with a dielectric constant of 3.5 using a standard PCB manufacturing process. The measured performance of this antenna is compared with the simulated results using the commercially available simulation software Ansoft HFSS, and it is found that the measured results and the simulated results are in good agreement.

Keywords