Mechanical Wave Propagation in Solidifying Al-Cu-Mn-Ti Alloy and Its Effect on Solidification Feeding

Abstract

The wave field in solidifying metals is the theoretical basis for analyzing the effects of mechanical vibration on solidification, but there is little research on this topic. This study investigated the wave field and its effect on the solidification feeding in the low-pressure sand casting (LPSC) of Al-Cu-Mn-Ti alloy through experimental and numerical investigation. The solidification temperature field was simulated by AnycastingTM, and the wave field was simulated by the self-developed wave propagation software. The shrinkage defect detection showed that applying vibration had a greater promotional effect on feeding than increasing the holding pressure. The predicted defects under vibration coincided with the detections. The displacement field showed that the casting vibrated harmonically with an inhomogeneous amplitude distribution under the continuous harmonic vibration excitation, and the vibration energy was mainly concentrated in the feeding channel. With solidification, the ux amplitude reduced rapidly after the overlapping of dendrites, finally reducing slowly to a certain level; the uy amplitude reduced dramatically after the occurrence of a quasi-solid phase, finally reducing slowly to near zero. Mechanical vibration produced a severe shear deformation in the quasi-liquid phase—especially in the lower feeding channel—reducing the grain size to promote mass feeding. The feeding pressure and feeding gap were changed periodically under vibration, causing the vibration-promoting interdendritic feeding rate to fluctuate and eventually stabilize at about 13.4%. The mechanical vibration can increase the feeding pressure difference and change the blockage structure simultaneously, increasing the formation probability of burst feeding.

Keywords

• mechanical vibration
• Al-Cu-Mn-Ti alloy
• low-pressure casting
• solidification feeding
• wave simulation