Microstructure and Mechanical Properties Analysis of Al/Cu Dissimilar Alloys Joining by Using Conventional and Bobbin Tool Friction Stir Welding

Abstract

The feasibility of producing welding joints between 6061-T6 aluminum and pure copper sheets of 6 mm thickness by conventional friction stir welding (CFSW) and bobbin tool friction stir welding (BTFSW) by using a slot-groove configuration at the joining surface was investigated. The microstructure of the welded samples was examined by using an optical microscope and X-ray diffraction. Furthermore, the mechanical properties of the weld samples are compared based on the results of the tensile test, hardness measurement, and fractography test. The slot-groove configuration resulted in the presence of a bulk-sized Al block on the Cu side. The microscopic observations revealed the dispersion of fine Cu particles in the stir zone. The presence of intermetallic compounds (IMCs) CuAl2, which are hard and brittle, lowered the strength of the weld joints. The strength of the weld joints produced with BTFSW was superior to that of the C-FSW. The maximum hardness values of 214 HV and 211 HV are reported at the stir zone for BTFSW and CFSW, respectively. The fracture location of all the joints was at the intersection of the stir zone and the thermomechanically affected zone was on the Cu side.

Keywords

• bobbin tool
• friction stir welding
• dissimilar
• intermetallic
• microhardness
• microstructure