The Effect of Casting Technique and Severe Straining on the Microstructure, Electrical Conductivity, Mechanical Properties and Thermal Stability of the Al–1.7 wt.% Fe Alloy

Abstract

This paper features the changes in microstructure and properties of an Al–Fe alloy produced by casting with different solidification rates followed by severe plastic deformation and rolling. Particularly, different states of the as-cast Al–1.7 wt.% Fe alloy, obtained by conventional casting into a graphite mold (CC) and continuous casting into an electromagnetic mold (EMC), as well as after equal-channel angular pressing and subsequent cold rolling, were studied. Due to crystallization during casting into a graphite mold, particles of the Al6Fe phase are predominantly formed in the cast alloy, while casting into an electromagnetic mold leads to the formation of a mixture of particles, predominantly of the Al2Fe phase. The implementation of the two-stage processing by equal-channel angular pressing and cold rolling through the subsequent development of the ultrafine-grained structures ensured the achievement of the tensile strength and electrical conductivity of 257 MPa and 53.3% IACS in the CC alloy and 298 MPa and 51.3% IACS in the EMC alloy, respectively. Additional cold rolling led to a further reduction in grain size and refinement of particles in the second phase, making it possible to maintain a high level of strength after annealing at 230 °C for 1 h. The combination of high mechanical strength, electrical conductivity, and thermal stability can make these Al–Fe alloys a promising conductor material in addition to the commercial Al–Mg–Si and Al–Zr systems, depending on the evaluation of engineering cost and efficiency in industrial production.

Keywords

• Al–Fe alloys
• electromagnetic mold
• severe plastic deformation
• equal channel angular pressing
• cold rolling
• ultrafine grain structure