Common-Mode Clutter Filtering for the Problem of Sounding Multilayer Media Using Ground-Penetrating Radar

Abstract

Eliminating common-mode clutter in data is one of the key aspects of road sensing with GPR. Common-mode interference can occur as a result of multipath propagation of an electromagnetic signal when the reflected signal from the same object arrives at the receiver from different directions and with different delays. Similar phenomena also occur when using antennas raised above the surface due to multiple reflections between the air–surface interface and the antenna. These interferences can significantly distort the data received by the GPR and interfere with the accurate determination of the parameters of the roadway. Therefore, the elimination of common-mode clutter is an important task to improve the quality of the obtained results. In this paper, we consider a method for filtering common-mode clutter in the radar data of the multichannel GPR “Terrazond”, which were obtained by sounding a test section of a highway. The results obtained during filtering can then be used to determine the thickness of the pavement layers using approaches that take into account the signal delay determined by the amplitude jump, for example, the common point method or if the permittivity of each layer is known. The obtained thicknesses of pavement layers are compared with the results obtained during core drilling by the Russian Road Research Institute.

Keywords

• multichannel ground-penetrating radar
• filtration
• determination of asphalt concrete thickness
• linear frequency modulated signal
• UWB