Вестник Дагестанского государственного технического университета: Технические науки (Jul 2019)
MODELING OF HEAT EXCHANGE AT TURBULENT FLOW IN FLAT CHANNELS WITH SYMMETRIC TURBULIZERS ON BOTH PARTIES
Abstract
Objectives. Mathematical modeling of heat transfer in flat channels with turbulators symmetrically located on both its sides, depending on the cross section of the turbulators.Methods. The calculation was carried out on the basis of a theoretical method based on solving the Reynolds equations factorized by the finite-volume finite-volume method, closed using the Menter shear stress transfer model, and the energy equation on multi-scale intersecting structured grids (FCOM), which was successfully tested in [23].Results. The article results of calculating the intensified heat exchange in flat channels with double turbulators of different cross sections (square, rectangular, semicircular, triangular) depending on the determining parameters were quite satisfactorily consistent with the existing experimental material, but having an indisputable advantage over the latter, since the assumptions made in their derivation cover a much wider range of defining parameters than the limitations found in the experiments (Pr=0.7÷100, Re=103÷106, h/dE =0.005÷0.2, t/h=1÷200).Conclusion. According to the results of calculations on the basis of the developed model, it is possible to optimize heat transfer intensification in flat channels with double turbulators of different cross sections, as well as control the heat transfer intensification process. As shown by the calculated data, with the intensification of heat transfer in the flat channels, symmetrical protrusions of square, rectangular and triangular cross sections, i.e. relatively sharp outlines, in the vortices up to the protrusions and behind them the production of turbulence is comparable to energy dissipation, which leads to increased hydraulic losses; for flat channels with protrusions of a semicircular cross section, i.e. relatively smooth outlines, the energy dissipation is much smaller, therefore, the hydraulic resistance in such channels is less. A detailed analysis of the structure of the vortex zones (main, angular, secondary, etc.) between periodic surface flow turbulators of square, semicircular, triangular and rectangular cross sections depending on the geometric and regime parameters of the coolant flow was carried out, the effect of the above vortex zones heat transfer and hydraulic resistance of the channel; additionally confirmed the optimality of application to abrutized turbulators, where hydraulic losses are much smaller than for sharp turbulators, which is directly or indirectly verified by existing experimental material [1—6].
Keywords
