Water jet as a novel technique for enamel drilling ex vivo.

Abstract

To investigate the usage of a water jet for enamel drilling ex vivo, 210 individual extracted molars without lesions or fillings were collected. Then, the specimens were drilled by a water jet or a high-speed dental drill. The cavities of 50 teeth were reconstructed digitally by micro-computed tomography (micro-CT) to measure the height and width. The cavities of 10 teeth were longitudinally incised and their surfaces were observed by scanning electronic microscopy (SEM). After the cavities were filled, 50 fillings were vertically incised. The bonding interface between tooth and filling was observed by SEM. 50 teeth with fillings were stained in 0.1% rhodamine B solution, and then the dye penetration between tooth and filling was observed under the stereomicroscope and confocal laser scanning microscopy (CLSM). The bonding strength between enamel and filling of 50 teeth was simulated and predicted with finite element analysis (FEA). At 140-150 MPa and for 2-3 s, cavities were made with a depth of approximately 764 μm in each tooth. SEM showed the cavity surface in the water jet group had a more irregular concave and convex structure than that in the high-speed dental drill group. There was a trend that the microleakage and bonding width was smaller in the water jet group than in the high-speed dental drill group. FEA indicated that the stress on the resin surface was greater than on the enamel surface in the water jet group. Compared with the tooth drilled by a high-speed dental drill, the tooth drilled by a water jet gained better retention of the filling material and suffered less bonding strength on the enamel surface. Water jet drilling is effective for enamel drilling.