Orthogonal experimental method to investigate the effect of process parameters on the mechanical properties of thin-walled parts by PBF-LB/M

Abstract

Abstract Lightweight thin-walled parts are widely used in the aviation and aerospace industries, and with the further increase in the complexity of their features, the traditional manufacturing process can no longer fully meet the high requirements of industrial component manufacturing. In this work, thin-walled parts are processed by Laser based powder bed fusion of metals (PBF-LB/M), and the effects of process parameters on residual stress, hardness, mechanical properties and microstructure of thin-walled parts are systematically investigated. The simulation results show that the maximum equivalent residual stresses are distributed in the combination of the solid and the substrate, and the minimum equivalent residual stresses are mainly distributed in the top two ends and the middle part of the solid, and the stress distribution is symmetrical. In addition, the maximum equivalent residual stress increases with the increase of laser power, and decreases with the increase of scanning spacing or scanning speed. The experimental results show that with the increase of laser energy density, the tensile strength and yield strength of thin-walled parts show a tendency of increasing first and then decreasing. Finally, high-quality thin-walled parts were successfully fabricated by the optimized process parameters, and their tensile and yield strengths were increased by 6.1% and 15.9%, respectively.

Keywords

• Laser based powder bed fusion of metals
• Process parameters
• Mechanical property
• Microstructure