Power harvesting footwear based on piezo-electromagnetic hybrid generator for sustainable wearable microelectronics

Abstract

As wearable microelectronics become more ubiquitous, and the size and power requirements of such devices decrease, there is increasing research interest in harnessing power from ambient environmental sources through embedded systems as alternative to battery replacements. Accordingly, a multimodal hybrid piezo-electromagnetic insole energy harvester (PEM-IEH) has been presented in this paper as a means to reclaim the biomechanical energy wasted in the surroundings during daily walking. The hybrid device consists of two piezo-ceramic wafer plates, two magnets, and two wound coils. The designed harvester has been simulated, fabricated and experimentally validated. From the frequency response, the hybrid harvester exhibits four resonant frequencies concentrated around 8, 25, 50, and 51 Hz. A maximum combined power of 1400 µW is generated across the optimal load resistances of upper and lower electromagnetic generators at first resonant frequency (8 Hz) under 0.5 g base acceleration, and a 269 µW peak power is obtained across the optimum load resistances of the upper and lower piezoelectric generators at 4th resonance (51 Hz) under 0.5 g. The miniature (46.8 cm3) and lightweight (43.3 g) harvester was incorporated into the sole of an adult-sized commercial shoe, and has been shown to be able to charge a 100 µF capacitor, up to 2.4 Volt within approximately 10 min of slow jogging. The capacitor charging performance presents a remarkable potential application of the harvester in development of micro-power monitoring sensors and wearable microelectronic gadgets where batteries pose a practical bottleneck.

Keywords

• Kinetic energy harvesting
• Piezoelectric
• Electromagnetic
• Insole
• Multi-resonant
• Wireless health monitoring