Drvna Industrija (Jan 2016)

Effects of Nanosilver-Impregnation and Heat Treatment on Coating Pulloff Adhesion Strength on Solid Wood

  • Hamid Reza Taghiyari,
  • Amir Samadarpour

DOI
https://doi.org/10.5552/drind.2015.1419
Journal volume & issue
Vol. 66, no. 4
pp. 312 – 327

Abstract

Read online

Effects of impregnation with a silver nano-suspension, as well as of heat-treatment, on pull-off adhesion strengths of the coating system on three commercial solid wood species were studied. The wood species included beech, poplar, and fi r. The size range of silver nanoparticles was 30 – 80 nm. The specimens were coated with an un-pigmented sealer and a clear fi nish on the basis of an organic solvent. The results showed that the highest and the lowest pull-off strengths were found in beech specimens heat-treated at 145 °C (5.7 MPa) and in nanosilver-impregnated poplar specimens heat-treated at 185 °C (2.5 MPa), respectively. Impregnation with nanosilver decreased pull-off strength in the case of all species as a result of formation of micro checks in the cell walls caused by the impregnation under high pressure in vessel. Heat-treatment at the temperature lower than 145 °C increased pull-off strength as to the irreversible hydrogen bonding in the course of water movements within the pore system of the cell walls, resulting in extra bonds among cell wall components and higher mechanical properties. However, heat treatment at the temperature higher than 185 °C significantly decreased the strength as the degradation of hemicellulose and cell wall wood components caused signifi cant decrease in mechanical strength and cell wall thinning. High thermal conductivity coefficient of silver intensified the impact of heat-treatment by rapid absorption of heat on the surface of the specimens.

Keywords