Fatigue Behavior of an Ultrafine-Grained Al-Mg-Si Alloy Processed by High-Pressure Torsion

Abstract

The paper presents the evaluation of the mechanical and fatigue properties of an ultrafine-grained (UFG) Al 6061 alloy processed by high-pressure torsion (HPT) at room temperature (RT). A comparison is made between the UFG state and the coarse-grained (CG) one subjected to the conventional aging treatment Т6. It is shown that HPT processing leads to the formation of the UFG microstructure with an average grain size of 170 nm. It is found that yield strength (σ0.2), ultimate tensile strength (σUTS) and the endurance limit (σf) in the UFG Al 6061 alloy are higher by a factor of 2.2, 1.8 and 2.0 compared to the CG counterpart subjected to the conventional aging treatment Т6. Fatigue fracture surfaces are analyzed, and the fatigue behavior of the material in the high cycle and low cycle regimes is discussed.

Keywords

• Al alloy
• severe plastic deformation
• high pressure torsion
• ultrafine-grained microstructure
• mechanical strength
• fatigue properties