Sustainable solidification of ferrochrome slag through geopolymerisation: a look at the effect of curing time, type of activator and liquid solid ratio

Abstract

Abstract Ferrochrome (FeCr) slag was used as a precursor for the synthesis of a geopolymer. The effect of KOH concentration, liquid solid ratio (L/S), content of potassium metalisicate (KS) or potassium aluminate (KA), curing time on the unconfined compressive strength (UCS) and metal leachability of the synthesised geopolymer was investigated. A 10 M KOH and an L/S of 0.26 yielded a geopolymer with a UCS 13.0 MPa after 28 d of ambient temperature curing. A 0.125 wt KS:KOH addition yielded a geopolymer with a UCS of 14.7 MPa whilst a 1.25 wt KA:KOH addition yielded a geopolymer with a UCS of 24.5 MPa. The increase in strength was due to the formation of Calcium Silicate (Aluminate) hydrate. The aluminate activated FeCr slag geopolymer was the most competent of all geopolymers synthesised as it resulted in over 97% immobilisation of Fe, Zn, Mn, Ni and Cr. The 360-d static leachability tests for the aluminate activated geopolymer yielded a metal release rate lower than 90 mg mm− 2 of the geopolymer. The aluminate activated geopolymer also was resistant to changes in wet and dry cycles as it had a UCS reduction of 42% after 10 cycles whereas the pure FeCr slag geopolymer and the silicate activated geopolymer had a UCS reduction of 91 and 72% respectively after 10 cycles. The aluminate activated geopolymer met the minimum requirements for use as a paving brick for low traffic pavements. The study provides opportunities for sustainable use of FeCr slag with minimal environmental impact.

Keywords

• Ferrochrome slag
• Toxicity characteristic leaching procedure
• Static leachability
• Unconfined compressive strength
• Wet and dry cycles