Applied Sciences (Dec 2020)
Fatigue Life Simulation of Tractor Spiral Bevel Gear According to Major Agricultural Operations
Abstract
The spiral bevel gear in a tractor, unlike the other gears in the transmission, is one of the most vulnerable gears in terms of fatigue life, as it is consistently driven throughout the operations of the tractor. Conventional fatigue life tests of transmission gears require expensive equipment and repeated tests, and do not reflect dynamic field loads. The aim of this study is to develop a simulation model which can replace conventional fatigue life tests for actual gears, in order to evaluate the fatigue life of a tractor using dynamic field load data. A transmission simulation model including a spiral bevel gear was developed using commercial software. In order to measure the dynamic load of the tractor according to various field operations, an axle torque measurement system was developed, and field experiments were performed for major agricultural operations occurring in the field. Fatigue life was calculated using Rainflow cycle counting (RFC), the Smith–Watson–Topper (SWT) model, and S–N curves based on torque data measured in the field. The fatigue life under moldboard plow tillage, subsoiler tillage, rotary tillage, and baler operation were 13,599, 285, 278,884, and 525,977 h, respectively. The fatigue life of the tractor, according to subsoiler tillage and baler operation, was 0.104 and 192 times the service life, respectively, where the difference between these two operations was about 1846 times. The fatigue life of the tractor, according to the attached implement type, was significantly different. Therefore, it can be seen that the fatigue life of a tractor can be significantly different, depending on agricultural operation type which the farmer uses most often; this can be used as basic data for tractor design and evaluation. In addition, it is considered that the developed simulation model can be applied to fatigue life evaluation using dynamic field load data.
Keywords