Local, Story, and Global Ductility Evaluation for Complex 2D Steel Buildings: Pushover and Dynamic Analysis

Abstract

A numerical investigation regarding ductility evaluation of steel buildings with moment resisting steel frames is conducted. Bending (µLϕ) and tension (µLδ) local ductilities as well as story (µS) and global ductilities are studied. Global ductility is calculated as the mean values of story ductilities (µGS) and as the ratio of the maximum inelastic to yielding top displacements (µGt). The ductility capacity is associated to drifts of about 5%. Ductility values significantly may vary with the strong motion, ductility definition, structural element, story number, type of analysis, and model. µLϕ is much larger for beams than for columns. Even though the demands of µLδ are considered an important issue they are less relevant than µLϕ. µS is much smaller than µLϕ for beams. µGS for dynamic analysis give reasonable values, but µGt does not. µLϕ, µS and µGS obtained from pushover are larger than those obtained from dynamic analysis and unlike the case of dynamic analysis, µLϕ tend to increase with the story number showing an opposite trend. Considering that: µGt for dynamic analysis results in unreasonable values, pushover analysis does not consider energy dissipation, the strong column–weak beam (SCWB) concept was followed in the model designs, and µLδ is not relevant in framed steel buildings, the ratio (RLG) of global to local ductility capacity is calculated as the ratio of µGS to µLϕ of beams, for dynamic analysis. A value of 1/3 is proposed. Thus, if bending local ductility capacity is stated as the basis for the design, the global ductility capacity can be easily estimated.

Keywords

• bending local ductility
• tensional local ductility
• story and global ductility
• moment resisting steel frames
• pushover and dynamic analysis
• ratio of local to global ductility