Sensors (Nov 2020)

Stress Estimation through Deep Rock Core Diametrical Deformation and Joint Roughness Assessment Using X-ray CT Imaging

  • Hanna Kim,
  • Melvin B. Diaz,
  • Joo Yeon Kim,
  • Yong-Bok Jung,
  • Kwang Yeom Kim

DOI
https://doi.org/10.3390/s20236802
Journal volume & issue
Vol. 20, no. 23
p. 6802

Abstract

Read online

In-situ stress estimation plays an important role on the success of an underground project. However, no method is error-free, and therefore a combination of methods is desirable. In this study, the in-situ stresses for a geothermal project have been assessed through the analysis of a deep rock core taken at 4.2 km, using the diametrical core deformation analysis (DCDA) method that relates the diametrical core expansion after stress relief with the stresses assuming elastic deformation. The extracted granodiorite core sample of 100 mm of diameter was intersected with a closed joint at a dip angle of 80.8° with respect to the vertical coring direction. The core sample was scanned using an industrial X-ray computed tomography (CT), and the diametrical deformation measurements were computed with CT slices. Results from using the DCDA method indicated an average horizontal stress difference of 13.3 MPa, similar to that reported for a nearby exploration well. Furthermore, the stress orientations were compared with the orientation of maximum roughness values. The results indicated a correlation between the orientation of the maximum horizontal stress and the orientation of the minimum joint roughness coefficient, implying a possible tracking of stress orientation using joint roughness anisotropy.

Keywords